Print and CUt Registration Marks

[dddemauro]

I am hopeful someone can help me out. I have ECAL software for my Eclips machine. I cannot for the life of me get the registration marks to get in the margins. I even put my design in the center of the page and no luck. I am only trying to print an image that is 4x4 inches, I have the mat set to 12x12 and the paper set to 12x12.

[papasue]

I found this post that might help.

http://joyslife.com/how-to-print-and-cu ... ix-eclips/

[HeatherM]

If you have your virtual mat set to Vertical (Portrait) orientation then the upper left corner (with the black triangle) prints is the upper left corner of your paper. I don't remember how it prints in the other orientation.

You can change your registration marks if you wish so that they are closer to your cut lines. I have my mark offset set at 0.10 cm so that I can fit more digi stamps on my cardstock.

Another thing to check is to use the cut preview button (magnifying glass over page icon) to see if you have a stray cut line or node that is causing the marks to be out farther than expected.