Craft Edge

firstcut wrote:If you end up with a lot of open paths, it may be easier to use the paint bucket tool to create new closed vectors. Set the tolerance to 2, set the grow/shrink to .5 (or whatever you need to draw the new line on top of the old one) and click once on each of the 2 closed shapes.

Kay, Is there a setting to fix the loss of any points with the paint bucket tool? That's one of the two big drawbacks I have seen using that tool. It isn't really that big of a deal with this file, but I have seen others where it is.

thanks Heather.

just an update. I followed your suggestions and now it looks better. One problem though: won't show in scal. I'll go over Kay's checklist to see if i can figure out what's wrong.

feeling so smart (I have a Tod's complex in this very second! both Tods!)

LOL

soraya

I did it!!!!!


thank you ladies so much for all your help. I went step by step and followed Kay's and Heather M. directions. Fool's proof!!!


sorry boys, In this moment I'm so Heather and Kay bright that I can't even stand myself!

soraya

here is the file, too