Page 1 of 1
Changing from Silhouette Studio to Sizzex Eclips Ecal
Posted: Tue Jun 12, 2012 2:55 am
by MrsE
I have just purchased a Sizzex Eclips with the Ecal software. I have previously used a craft robo with silhouette studio (designer edition) software. I have tonnes of files in .studio format - is there a way I can convert these and use them in ecal??? Thanks in advance
Re: Changing from Silhouette Studio to Sizzex Eclips Ecal
Posted: Tue Jun 12, 2012 7:51 am
by sstehman
I "believe" the Silhouette has the option to save the file as an .svg. If so you can then open the svg in eCal. I don't have the software, but check it out.
Re: Changing from Silhouette Studio to Sizzex Eclips Ecal
Posted: Wed Jun 13, 2012 1:08 am
by MrsE
Thanks for replying. Unfortunately, my version of Silhouette Studio Designer edition doesn't allow me to do that. Any other ideas, anyone??
Re: Changing from Silhouette Studio to Sizzex Eclips Ecal
Posted: Wed Jun 13, 2012 6:54 am
by sstehman
Do you have an export feature? What file formats "can" you save as?
Re: Changing from Silhouette Studio to Sizzex Eclips Ecal
Posted: Wed Jun 13, 2012 8:40 am
by Deloris
Check out this discussion on the Silhouette Plus forum:
http://s15.zetaboards.com/Silhouette_Pl ... 830/2/#new
Kelly posted on #23 that she had Studio 1.9 version where you can save as a svg file.
If the download link doesn't work, try contacting Kelly to see if she can send you the Studio 1.9 installation file so that you can save all your studio files in svg format.
Re: Changing from Silhouette Studio to Sizzex Eclips Ecal
Posted: Fri Jun 15, 2012 7:16 pm
by bestcee
This is pretty long, especially if you have a lot of files, but I tried this and it worked:
http://www.scrapyourstory.com/tutorial- ... e-cutters/