Cuts Not Completing

[ssuzanlyn]

WHich blades are you buying from them I went to the website but cant find them..??? Thanks

[GrammyKrausse]

WHich blades are you buying from them I went to the website but cant find them..??? Thanks

are you wanting the 90 degree blade? They are the same as the deep cut cricut blades. If you need it right away you can usually pick them up at Walmart with the Cricut stuff. They will have the same red top. Also if you have a sign shop close by might try calling them and asking them if they will sell you a Roland 90 degree blade or two. Some will and some wont. Good luck.
Grammy

[cmsmith64]

So far, knock on wood, I have no problem with SCAL2 and it cutting to my Expression. Now MTC...well ever since I upgraded (and was assured that I would not have any problems upgrading since I have the plugin for cutting...hee,hee) it either will not cut at all or will cut a file and stop mid-way (not even mid-way) in the cut and come up with the stupid message to check the usb cable, making sure it's plugged in. Yeah, right...I have it plugged in, the com port is correct...and still causes shut-down. I use MTC for designing purposes now, export cut file as a svg file and than use SCAL2 to cut it out. Sorry I don't have money to replace the Expression, and not sure what I would upgrade to b/c of the compatibility with SCAL2 software with the machine! So until the Expression gives up the ghost, I will continue using it.


Carolyn

[scrappindeb]

WHich blades are you buying from them I went to the website but cant find them..??? Thanks

If you go on the webpage I put in previous post, choose the "Extra Long Life " carbide blades for Roland plotter.
60 Degrees is the selection to choose and they are $14.99 right now.
I usually get them cheaper on their ebay listings.
Good Luck!