needing a little help...

courtneyray · Post by **courtneyray** » Thu May 19, 2011 7:28 am

I have this file that a friend of mine wanted me to etch onto a glass for her. I need to get it to a file that has much less detail but when i "trace" it it has way too many pieces. i would want it to be the outline of the fish and the stripes on it to be just solid stripes, if that makes sense. Any help is greatly appreciated!

: striped_bass_large.gif (38.9 KiB) Viewed 9231 times

DogCarbon · Post by **DogCarbon** » Fri May 20, 2011 7:27 am

I tried to clean this up... hope it works for you!

DogCarbon · Post by **DogCarbon** » Fri May 20, 2011 7:36 am

I then simplified the svg even more, because I didn't know how much detail you wanted.

Both files are for personal use only.

hkvalerio · Post by **hkvalerio** » Fri May 20, 2011 11:20 pm

Wow! That came out really nice DogCarbon. Hope Courtney likes it!

gj1 · Post by **gj1** » Sat May 21, 2011 3:21 am

Outstanding job!

courtneyray · Post by **courtneyray** » Mon May 23, 2011 1:10 pm

thank you! thank you! thank you! its perfect!

DogCarbon · Post by **DogCarbon** » Mon May 23, 2011 1:47 pm

courtneyray wrote:thank you! thank you! thank you! its perfect!

Good, I am glad you can use it!

Craft Edge

needing a little help...

needing a little help...

Re: needing a little help...

Re: needing a little help...

Re: needing a little help...

Re: needing a little help...

Re: needing a little help...

Re: needing a little help...