I have been trying to cut 3D roses, but when they are cutting it scores right across therefore I cannot role them into shape, can anyone tell me what I am doing wrong, I have cut these in the past and they were okay.
Thanks in advance,
3D Roses
-
HeatherM
- Posts: 3913
- Joined: Sun Jan 11, 2009 7:16 am
- Location: Michigan, SCAL1; SCAL2; eCAL; Windows7 64 bit; eCAL Mavericks
- Contact:
Re: 3D Roses
Make sure that the file is not touching the cutting boundary. Your file probably has an open Path, and SCAL2 will connect the end-points if it is touching the cutting boundary. I usually use the alignment tools, then give it a nudge away from the edge. Preview will also show if SCAL will add the closing line. I have a thread on this in the bugs section. http://forums.surecutsalot.com/viewtopi ... =7&t=17956