Video Tutorial for Print/Cut SCAL 2.038

papasue · Post by **papasue** » Mon Dec 20, 2010 12:36 pm

Here's one. I didn't get around to it today but found this one.

http://www.youtube.com/watch?feature=pl ... 4AKEBDN6Tw

hellie0h · Post by **hellie0h** » Tue Dec 21, 2010 6:46 am

Oh my gosh, thank you for posting that video. How simple and cut almost perfect, I think my paper alignment was off just a tad...but very happy with the results. Thanks so much!

prussc · Post by **prussc** » Tue Dec 21, 2010 5:24 pm

I am able to open SCAL 038 now but when I place image and try to see a png or a jpg (Paulo's starry girl or Kristal's gingy baby) I only get an outlined rectangle. I can bring in the svgs without a problem. Any idea what I need to do to see the graphics?

firstcut · Post by **firstcut** » Tue Dec 21, 2010 5:29 pm

Make sure show outlines only is unchecked under the view menu.

prussc · Post by **prussc** » Tue Dec 21, 2010 5:42 pm

Okay figured out with Kay's help how to see the image but now I am getting the firmware warning again. This is strange

pastda3 · Post by **pastda3** » Fri Dec 24, 2010 10:23 pm

I can't figure out what I'm doing wrong, but I CANNOT see an image.

papasue · Post by **papasue** » Fri Dec 24, 2010 11:07 pm

pasda3, you have to uncheck view/outline only. The picture you placed should now be there.

Craft Edge

Video Tutorial for Print/Cut SCAL 2.038

Video Tutorial for Print/Cut SCAL 2.038

Re: Video Tutorial for Print/Cut SCAL 2.038

Re: Video Tutorial for Print/Cut SCAL 2.038

Re: Video Tutorial for Print/Cut SCAL 2.038

Re: Video Tutorial for Print/Cut SCAL 2.038

Re: Video Tutorial for Print/Cut SCAL 2.038

Re: Video Tutorial for Print/Cut SCAL 2.038