Help With Cameo and SCAL 3

[toggletails]

After downloading the newest SCAL 3 update?? for my Cameo, my machine will not cut. The message is "Project sent to cutter", however
nothing happens. I uninstalled and reinstalled and still having problems. I should have left the update alone as I wasn't having any trouble til I downloaded that as
recommended on the site.

[papasue]

Hi, this is a "member" supported forum and CraftEdge only sometimes comes by. I suggest that you contact them directly as they are really good and fast and you will get the correct answer.

Here is the link to the form to fill out with all the information you have.

http://www.craftedge.com/support/support_form.html

I hope to see you back here with a on your face.