Craft Edge

I haven't been able to get scal 2 to weld anything, need help.Asking and getting no responce from anyone.
Thanks Jan

What are you trying to weld? Can you say what it is (words, shapes, svg), what you have tried, and what happens? It might help if you could post a file that you haven't been able to weld.

Click on the link and it will take you to an area where it will explain how to do this.. Hope it helps you http://www.youtube.com/watch?v=qKCF4_-AU6c

Trying to weld a snowflake on side of square, when it cuts there is no snowflake. Didn't have trouble until I upgraded to scal 2

So you are using the shapes from the program? Can you attach the file?

How do I attach file

When you make a post, there is a "choose file" button. Click on that, select your file, then "add the file".

hope this works

I just tried to add a star to your envelope and it didnt cut, or show up in preview

It looks like you are trying to cut shapes from inside other shapes. Just put the shapes inside and don't weld. They will cut fine like that. HTH