Craft Edge

I cut chip board last night with a deep cut blade.......... it was a simple cut file ........ straight lines .......... however ........ because it was going so fast and the chip board is thick ....... the lines were NOT straight.
I think if we were able to control the speed it would have been straight.

So .......... please include speed control.

Blessings
Nicole

Go to Edit>Preferences. There is a speed setting there.

In the edit tab, then preferences, you can slow the speed way down. I do this a lot; even though sometimes it feels like you can go make dinner while you're waiting, but it's worth it if things need it. I'm not sure if the speed dial on the cricut works while SCAL is in control or not?
Donna