inkscape
Posted: Wed Sep 30, 2009 1:51 pm
IS THERE A INKSCAPE FOR DUMMIES TUTORIAL. I've followed all steps but I cannot figure out how to cut is piece separetly
Page 1 of 1
Re: inkscape
Posted: Wed Sep 30, 2009 1:59 pm
Post up your file and I am sure one of the kind people here on the forum will be able to assist
Re: inkscape
Posted: Thu Oct 01, 2009 10:20 am
Thanks for your quick response, I took the attitude of the little engine that could (I THINK I CAN - I THINK I CAN) and low and behold I did I was able to make a cut file of powerpuff girls bubbles, I am so proud of her and myself....Thanks again for the offer to post and help....
Re: inkscape
Posted: Thu Oct 01, 2009 2:00 pm
Well done.
You should be proud, it is abit intimidating at first if you have never used the program before.
There is so much help available around the the place and it is just a matter of putting all the little bits of information together.
Well done again
Cheers
Craig
You should be proud, it is abit intimidating at first if you have never used the program before.
There is so much help available around the the place and it is just a matter of putting all the little bits of information together.
Well done again
Cheers
Craig