Craft Edge

I have a pdf I opened in Inkscape and saved it as an svg. When I import into Scal all is upside down. Everything is fine except it's upside down. Does anyone know what causes this and is there something I can do to fix it.

Did you hit object to path and then save it??? Are you sure your computer monitor isn't upside down?? ROFLMAO.. sorry.. had to throw some humour in there..lol

Grammy,
I have this happen a lot and have never been able to figure out why, but it is easy to fix. If it is just cutting upside down then you don't have to do anything, just turn the cutout around after you pull it off the mat. Mine are always flipped, too, though. In that case, rotate and flip in the opposite direction in SCAL so that the SVG cuts correctly.

firstcut
I hadn't noticed it before but you are correct it also is flipped. I think it had something to do with how Provo Craft did the pdfs for Tinkerbelle booklet. Followed your suggestion though and turned it upside down and flipped it in Inkscape saved it and when imported in SCAL it was just fine. Thanks for the hint.
Grammy