Craft Edge

I keep getting the message 'USB device has malfunctioned and windows doesn't recognise it' when I try to connect my cricut to my computer. This has happened since installing SCAL V2. Have also tried removing Design Studio and reinstalling it. It seemed to solve it for a while then I got the same message again.
Anyone else have the same problem?
Angie

how about updating the firmware or drivers again?
Karen

Do you mean the Design Studio download? Have done this about 6 times but the problem keeps coming back.

I think she is refering to your drivers, not your DS software. Sometimes the drivers for some reason or other gets corrupted and no long work properly. Drivers are a software that you download to cause your computer to recognize accessories like printer, Scanner, Cricut. Camera etc.
Grammy

How do I go about updating them?
Angie

Go here and look to bottom of page where it talks about drivers. If this is still makes you uneasy. Contact customer service from th is site and tell them what's going on. I have never had this problem so What I would do is grab my husband at lunch and make him do it. LOL

http://www.craftedge.com/products/products.html

Thank you for our help will go and have a try.
Angie

Tried reloading drivers, but no change. Swapped over USB cable with printer and seems Ok now. Keeping my fingers crossed that's all the problem was. Thank you for your help.
Angie

k, mine is working perfectly the only thing is that I can't load my mat on the cricut none of the buttons work and SCAL is asking me to load the mat. What do I do and How? Thanks a billion. By the way, did I mention I'm like very very new to this?

Thanks

Try the reset that GrammyKrausse posted here. http://forums.surecutsalot.com/viewtopi ... 56&p=33645

If that doesn't work, and your Cricut is still under warranty, you will need to contact Provo Craft since it sounds like a machine issue. DO NOT tell them that you have SCAL!