Page 1 of 1
Cricut updated firmware, SCAL won't work anymore, True????
Posted: Fri Mar 27, 2009 6:30 am
by kkscraps
I was just thinking about purchasing SCAL software but was doing some research on it and saw on a couple of websites that as of March 21, 2009 Cricut updated the firmware (which I haven't checked yet) and now the SCAL software doesn't work anymore. I was browsing thru the SCAL boards and noticed a lot of problems since then with the Cricut not working and freezing up. Is this true and if so, has craft edge come up with a solution. I'd like to try to find out before I spend $75 on the software. HELP!!!!
Thankskkscraps
Posts: 1
Joined: Fri Mar 27, 2009 9:22 am
Private message
Re: Cricut updated firmware, SCAL won't work anymore, True????
Posted: Sun Mar 29, 2009 11:00 pm
by Tingha Treasures
At this present time SCAL is working on the Cricut as long as you have the correct firmware.
Check the Craft Edge website for more info
http://www.craftedge.com/support/faq/fa ... salot.html
You can buy SCAL for a lot less than $75
Re: Cricut updated firmware, SCAL won't work anymore, True????
Posted: Mon Mar 30, 2009 9:00 am
by kkscraps
Where can I buy SCAL for less than $75?
Re: Cricut updated firmware, SCAL won't work anymore, True????
Posted: Mon Mar 30, 2009 9:01 am
by kkscraps
Where did this thread go? There were lots of posts. Anybody notice that????
Re: Cricut updated firmware, SCAL won't work anymore, True????
Posted: Mon Mar 30, 2009 9:10 am
by deliacm
It's in a bunch of posts that, of course, I can't find right now.
http://store.candacraft.com/ This store has it for 59.99, I believe.
Re: Cricut updated firmware, SCAL won't work anymore, True????
Posted: Mon Mar 30, 2009 12:42 pm
by Tingha Treasures
Yes thats the one I was off looking for it last night (aussie time)
Theres people on ebay USA I believe with some good packages, come with Cds of SVGs and fonts etc.
Re: Cricut updated firmware, SCAL won't work anymore, True????
Posted: Wed Apr 01, 2009 5:16 pm
by kkscraps
Thanks deliacm.