Craft Edge

Does anyone know how to do this? I am trying and can not get it to look like this. I have tried just about everything and am getting frustrated. I don't have a problem with Academy. The font is called God of War and it's free from Dafont. Can anyone guide me on how to do this. I would greatly appreciate it. TIA

I have SCAL3

This is tough. I cannot do it from scratch as breaking out the S to go over and under was to much. It would seem like exclusion or intersection should work and it didn't. I was almost successful with tracing your image. The red lines were also a problem so I created a draw line on the white back mat

It is no perfect but if this will get you started here you go. I am ttaching some basic instructions you can grab and print and the .scut3 file I created and cut. I used a thin marker pen but I think a RED bic would work better. If you do not have the pen holder for your cutter you could P2C that back piece, same with the ACADEMY with a silver or white pen on the leg of the R.

I hope this gets you going. Please ask if I've missed a step or if you have any more questions. I always learn something trying to use only eCAL and I'm getting there.

Anyone else have ideas on HOW TO?

Thanks, still working on it. Hoping he gets me a better logo.