Page 1 of 1
Calibrating SCAL3 for Silhouette Cameo
Posted: Sun Aug 03, 2014 8:44 am
by dragonetta
Every time I cut with Scal3 on my Silhouette Cameo everything is too far to the right. Can anyone please tell me how to get it to move to where it should be. I can't figure out how to get it to calibrate.
Thanks
Jill...
Re: Calibrating SCAL3 for Silhouette Cameo
Posted: Mon Aug 04, 2014 3:56 am
by talanhart
Do you have the artboard alignment correct? Look for the arrow. It should be at the top or the side and that is how it is fed into your machine.
Re: Calibrating SCAL3 for Silhouette Cameo
Posted: Fri Dec 19, 2014 6:38 am
by Kim43
Dragonetta- did you ever find a solution to your problem? I'm having a similar issue with my new Cameo and SCAL4. It's an inch off at top and bottom. Thank you!