Craft Edge

The posts on the forum are really quiet. I know there is a Facebook group too and the posts are in abundance there. I hope this forum does die off as it is our direct link to CraftEdge that lead to software improvements. If you are visiting both groups, please remember this one and post your projects here too. There is a project section. It really does help all that support SCAL.

Hi Sandy. Maybe everyone is busy getting ready for the holidays. I have to admit that I kind of abandoned ship due to low participation. I feel like it started to fall apart when all the different e-cutters came into play. There were too many questions that I wasn't able to answer. I'll have to make a point to get in here and be a little more active.

I still use SCAL with my Cameo almost every day. I would be lost without SCAL & Inkscape! I prefer it over the Silhouette Design Studio. I didn't realize there was a FB group.

There is and it is set up and managed quite nicely. Put a message on their page too so the forum is not abandoned as it is "the" link to CraftEdge. I understand busyness for sure as I hardly have time to play with my machine, but this time of year many are creating as part of their holiday gift making.

Hope the little post reminders encourages members to post pics of their projects.

You are right...some of the questions I can't field with all the cutters on the market.

Hey Sandy!

I am still here, checking in most days.

I think here are too many FB groups, too many posts asking the same thing and you can't find what you want easily, but maybe I have not put my time into the FB groups to figure them out either..... I prefer it here

So where do you go to get to their facebook page. I typed in CraftEdge and that wasnt it.

will post the page later. I can't get to FB at my job. It is a Sure Cuts A Lot (SCAL) forum...if you want to do a search.

Here is the link to the FB group.

https://www.facebook.com/groups/409724385786375/

Thanks.

Hmmm. It FB page looks like it's for eCal and the Eclips. I use the Cameo.

Here is the link for SCAL

https://www.facebook.com/pages/Sure-Cut ... 6399332239