Craft Edge

I haven't used SCAL in a while and when I open my shapes library it is empty..... I'm sure this is operator error........ any directions would be appreciated. I've been looking at videos but the one I think I need is no longer available.

hi, you could reinstall if you still have the install software, if you have scal3 you can download the software again or

if you have scal2 for circuit you would have to contact support@cratftedge.com to see if you could download scal2 again.

now if it operator err, can you list the steps to get to the shapes library

Which vs of SCAL are you using with the version number please.

we will help if we can.