Craft Edge

Good morning all,

I am a total newbie. Don't have SCAL....YET. So want it, but my cpu is dying. I am looking at a laptop but just need to know if SCAL is okay with a 64 bit processor? Can anyone tell me for sure? Thanks so much!!!!

You might send an email to Todd - you can use the form on the support tab of the CraftEdge website.

YES IT IS COMPATIBLE!!! SCAL is one of the few programs that IS compatible w/ the 64-bit processor. I've been running it on my 64-bit for months...... but one hint: it does tend to freeze a bit if you hold down the "move" key too long so make sure you set the program to run in XP compatibility mode. Easy peasy! (and WONDERFUL!)