Page 1 of 1
Help!
Posted: Wed Jul 13, 2011 7:19 pm
by pkkubena
When I try to trace this in SCAL, the inside (green parts) don't show up. I have tried working on it with Inkscape but am not having much luck. Any idea why it is doing this? I would be happy to pay one of you Inkscape experts if you could help me with this. Thanks!
Re: Help!
Posted: Wed Jul 13, 2011 8:04 pm
by Sweetness4713
I'm going to give you a little lesson here to help you out.. Beside the svg on your tool bar in scal use your trace image.. So you get that other box that opens up ... go get your saved image... then on your brightness settings adjust the numbers.. you'll notice I have the number set to 71.. and there you go.. all the parts of your image show
...
Re: Help!
Posted: Wed Jul 13, 2011 8:16 pm
by pkkubena
Thank you sooo much! You have no idea how long I have been working on this. Thanks again!
Re: Help!
Posted: Wed Jul 13, 2011 8:17 pm
by pastda3
Sweetness - Thanks for this lesson. You also taught me something new. I don't play around in SCAL too much, because I just usually do everything in Ink. Too much to learn!
Re: Help!
Posted: Wed Jul 13, 2011 9:29 pm
by Sweetness4713
You are both so welcome.. it's all in the matter of adjusting the brightness number..
..