folded castle card
Posted: Wed Sep 10, 2008 11:48 pm
Ok here we go.
I have attached (I hope) two .scut files. One has all the 4 castles on a 12x24 cutting mat and them all welded together so can just be cut.
The other one has all 4 castles on a 12x12 mat. The first two are welded together and the last two are welded together and I have put a small tab at the end of the second castle so they can be joined together after cut.
If you want each one separately then just un-weld them and cut each one - attach a tab to each one if you want.
Hopefully also is an image from Inkscape of how the 4 layers would sort of look when all cut out.
As I said in another post, I have not yet cut this so no guarantees. Each castle is 4 inches long. I had to make a few changes from the original image supplied by bdhardy as curves were a little tricky so I stuck to straight lines so I could get everything symetrical.
Let me know how it goes. I would love to see any made if the scut files work.
Raewyn
I have attached (I hope) two .scut files. One has all the 4 castles on a 12x24 cutting mat and them all welded together so can just be cut.
The other one has all 4 castles on a 12x12 mat. The first two are welded together and the last two are welded together and I have put a small tab at the end of the second castle so they can be joined together after cut.
If you want each one separately then just un-weld them and cut each one - attach a tab to each one if you want.
Hopefully also is an image from Inkscape of how the 4 layers would sort of look when all cut out.
As I said in another post, I have not yet cut this so no guarantees. Each castle is 4 inches long. I had to make a few changes from the original image supplied by bdhardy as curves were a little tricky so I stuck to straight lines so I could get everything symetrical.
Let me know how it goes. I would love to see any made if the scut files work.
Raewyn