Page 1 of 1
Using SCAL with Wishblade
Posted: Tue Mar 15, 2011 10:51 am
by Scramper
Hey - I've been searching for about 30 minutes for something that tells me how to use SCAL with my Wishblade. I think the Wishblade would have to be set up as a printer? But then how do I cut to it? Anyone know where there might be a tutorial/directions, etc?
Re: Using SCAL with Wishblade
Posted: Tue Mar 15, 2011 10:59 am
by HeatherM
There is a section in the in-program help about this. Open SCAL, then from the menu: Help/Help/Basics folder. Click on the Basics folder, then the Cutting with CraftRobo page. HTH
Re: Using SCAL with Wishblade
Posted: Tue Mar 15, 2011 3:29 pm
by Scramper
Thanks Heather!