Page 1 of 1
Need info re: Wishblade & SCAL please.
Posted: Sat Mar 12, 2011 4:15 pm
by He**inwa
Where would I find info on using SCAL with my blue wishblade or can it be done?
Does it just need to be installed as a printer, with a driver?
TIA!!
Re: Need info re: Wishblade & SCAL please.
Posted: Sat Mar 12, 2011 4:18 pm
by Sweetness4713
It's only good with Craftrobo, and cricut and ecraft machines..
Re: Need info re: Wishblade & SCAL please.
Posted: Sat Mar 12, 2011 4:24 pm
by He**inwa
Since my blue wishblade is the same as a craft robo, just with a different label, where do I find the instructions?
I can use robomaster software with it, so I am relatively sure that it's do-able.
ETA: make that the original robomaster, I haven't tried the new.
The worst thing that can happen is that it doesn't work.
Re: Need info re: Wishblade & SCAL please.
Posted: Sat Mar 12, 2011 4:33 pm
by He**inwa
I found the email that support sent me.
It says craftrobo/wishblade/silhouette
(all were manufactured by graphtec with different labels)
I was correct in thinking that it need to be installed as a printer, which does take away the traditional print and cut capability that was a big selling point for wb.
Here's the page with info:
http://www.craftedge.com/tutorials/cut_ ... trobo.html