Craft Edge

I am looking for a Frankenstein wrap to use on a 2 liter soda bottle. Does anyone have one of these?

I'm not sure what you want. Is this just a square label or something with a cut out design like the Cupcake Wrappers?

I was thinking something like a total wrap. A paper piecing file. Hair would be seperate wrap and then you have eyes perhaps the bolt in the neck. Gee its starting to sound difficult. Not forgetting the scars. I am using the bottle as a gift bag of sorts. I have seen these all over the net. Just not a Frankenstein . I wish I could master inkscape to be able to create what I think of.

Post a link of something that you think is close to what you want.

Would something like this work? The black part has a white line that would cut. The back portion or the square parts would wrap around the bottle and the Frankenstein part would stick out away from the bottle. You would have to piece the rest of Frankenstein on top of the Black part.

Oh you did a great job! What I was looking for was more of a Frankenstein head. With the whole label being the head.

Do you have a Frankenstein Head that you want to use? Will anyone work? I will work on this tomorrow using the same principle.

Todd, this is wonderful. Do you have it in SVG format?

Thanks loads.

Sharon

I'm sorry, but I don't have this in an SVG. I saved my file as a JPG and before I could save it as an SVG, my computer froze and I had to restart. Did you want just the Frankenstein? That I can get for you.

Thank you Todd. Yep I think pretty much any one would do. Thanks for your time.