Craft Edge

Thanks to all for this, As Todd said
"Because it is so cool"

Hi. Happy Thanksgiving to everyone. Is there any way possible that one of you wonderful generous people would be able to do the rolodex card withOUT a top tab? I am in need of a plain card, no tabs on the top, just straight across. I would be so thankful if someone was able to provide this.

No Tab.

Thanks!

Thanks Todd. You are the best. Have a Happy Thanksgiving.

I just downloaded the file and there is an extra set of holes just sitting off to the right. Just break apart and delete them.

Hi. I just tried to open the rolodex files with the various tabs and I keep getting a failed to load message saying no vectors available. Is anyone else having the same problem with them? I was able to open and use the one that I requested from Todd (no tab-just straight across) and thought that I could actually use one of the tabbed ones. Any advice or help would be greatly appreciated.

I just tried my original file and it worked. I wasn't able to open the other file either. If you want to move the tab, you can use the node (Shape) tool. Select the tab only by drawing a box around it. You should see the nodes of the tab highlighted. Now you can move it either to the left or right. I just did this and now I have something to add to the wish list.

Thanks. Once again you come to the rescue of someone who is just not all the technically savvy. You are a very generous person. Thanks for all you do for us. I will give your instructions a try after I finish doing all of my Thanksgiving dishes!!