windmill
Re: windmill
I have tried different ways including the ungroup but either it doesn't show up in scal or horses still on top of windmill...help !!!
Re: windmill
I took the horses out and went into scal and then added the horses...it cut the horses seperate....any ideas how to get it to cut just one piece...thanks Judy
- Attachments
-
- windmill horses pear bush sun.scut
- (45.79 KiB) Downloaded 90 times
Re: windmill
Ok I finally figured out what you meant by being seperate groups....even though it appeared to be one there was broken lines around the horses..I ungrouped the horses and took them off the page and then brought one back and finially got it grouped and then brought the other horse in and finally got it to weld to the whole picture..a pain pain pain....thanks so much for all the help...here is the file again but still not sure how to show the picture so no one has to download it to see it unless I just have to take a picture and then it will show....thanks again !!! and here is the finished file...sorry guys and girls but I am from South Texas and this is my love...horses, windmills and pear bushes ( catus)
- Attachments
-
- windmill sun and pear bush horses.svg
- (27.55 KiB) Downloaded 104 times
Re: windmill finished
hope this come through.....took the picture with my camera..in a hurry so not the best picture..thanks everyone !!!!!!!!!!
- Attachments
-
- windmill sun and pear bush horses.svg
- (27.55 KiB) Downloaded 167 times
-
- MVC-343F.JPG (46.91 KiB) Viewed 1575 times
-
- Posts: 3913
- Joined: Sun Jan 11, 2009 7:16 am
- Location: Michigan, SCAL1; SCAL2; eCAL; Windows7 64 bit; eCAL Mavericks
- Contact:
Re: windmill
The print screen button is usually located near the upper right of the keyboard, but can vary some.