table tents

[jrichards]

I would like to make table tents for my mom and dad's anniversary party. I tried to design them but alas I cannot. I would like them to be 3.5 wide and 4 tall so that they would fold in half and then a circle would pop up from the fold on the right hand side, actually, a half circle. I am going to put their choice of entree on the circle somehow. I had it almost right but I used the half circle and of course that cuts it all the way out. I couldn't figure out how to eliminate the line at the base of the half circle so that I only had an arch. Does this make any sense???? Can someone help me with it please? Thanks.
Jan

[Sweetness4713]

Is this what you are wanting ???

[Sweetness4713]

When you are doing your half circle. Go object/path.. then click on the nodes option on your tool bar.. then click the two end nodes on your half circle making sure they are both highlighted then click on break nodes and then break apart.. then delete the line..

[pastda3]

I wasn't sure wide you wanted the circle to be so I made is 1.5 inches. Sorry I don't have time to post a pic.

[pastda3]

I'm just too slow.

[Butterfly]

Here you go I can't find it here on the forum But this is where I got it. Here is a way to do some fancier ones if you want to

[jrichards]

Thank you all so much, that was all I needed. It is so great to know that all I have to do is ask and you all will be there to help. Pastda3, Sweetness, and Butterfly I appreciate your help and your quick response! My mom will be thrilled!
YOU GUYS ROCK!!!!!!!
Jan