Craft Edge

I would love to be able to enter a size for smaller papers, not just mat size, so the cutter will work within the size range of the paper, not just the mat.

Can't you just make your paper be the same size as the cut based on the the number of inches it takes up on the mat? You can put bits of pieces of paper on the mat - it doesn't have to be a full sheet. Just make sure the paper covers all areas where the blade will cut.

I would also love to have a selectable paper size, and the ability to "fit to paper", etc.. so that I wouldn't need to figure it out myself. Just having selectable mat sizes isn't quite enough.

maybe customizable mat sizes? I would love to be able to work in a 24x12 mat (rotate the mat instead of all of the elements on the mat) - just for the workspace - yet would understand that I could only cut as large as the machine would take.