Craft Edge

Hi,

In the past I had a Craft Robo and it was nice because I could print a design and then cut it. I don´t know if it is possible with SCAL, but it would be very nice, to print with a regular printes and then cut with Cricut.

tks
Luciana

Several of us have been working on this quite a bit, here is a thread to check out
http://forums.surecutsalot.com/viewtopi ... ted#p26990

I do this alot. Blackout your image if you need to, & cut it. After it is done cutting, press "Load" not "Unload". You want it to cut in the same exact place. Carefully lift up the paper without shifting it on the mat, and take out the piece that was cut. Insert your printed image, take off the previously cut paper, and press cut. Works every time!