Page 1 of 1
leading and trailing lines
Posted: Fri Mar 06, 2020 6:18 pm
by taz
- SCALP5 octagon
- SCAL5P1.PNG (12.26 KiB) Viewed 7373 times
- Easy cut octagon
- EasyCut.PNG (9.1 KiB) Viewed 7373 times
- Basic arrow
- SCAL5P2.PNG (22.14 KiB) Viewed 7373 times
I just switched from Easy Cut to SCALP5. everything looks ok until I go to cut or draw. depending on the item I get leading and trailing lines. I have overcut set to 0. in SCAL5P2 the pen goes from start point to the 5 cutting through the arrow, on the Octagon it is leading and trailing cuts.
Anyone know if there is a setting or adjustment somewhere. (ignore the size difference. I didn't think to make exact size, but doesn't matter.)
This example is with a pen, because I already ruined a decal...
Using Saga cutter
Re: leading and trailing lines
Posted: Sun Mar 08, 2020 7:36 am
by SandyMcC
Even though you responded on Facebook that you figured it out, I thought I'd go ahead and answer here what you discovered. There are two Saga cutters available in SCAL's menu of cutters: Saga and Saga ARMS. The wrong one was selected in SCAL.