Craft Edge

Here is my project I have been working on and finally cut in vinyl to put on stained glass to etch....my glass had to much color but now I know what color and depth of color I need...this is cut on a 12 x 24 mat...really pretty on colored paper also...thanks to all of you who stuck with me threw this and Susan and Dan for their very very good tutorials....

Sorry everyone who have downloaded this file..I adjusted the fans on the windmill and fixed the water trough...so sorry just have been working so didn't notice them untill now..this file looks better to me.....still learning...thanks

here is the picture I think with my screen shot...thanks for helping with the screen shot..just get smarter and smarter everytime I open this forum....
the picture is not true of the original file in the above message...it is really very smooth

Very Cool! Please post a picture of your finished project.

thanks, it may be sometime ...need to find some different glass.....thanks !!!

when i inport it into scal it is blank

I am sorry...I just downloaded it and saved it in my documents to make sure it was different than the original file and opened scal and clicked on import svg and it came up.....if you like email me and I will send the file to you that way if you like....maybe someone here can help you....let me know !! thanks and sorry for the trouble !! Judy

i downloaded it again it worked fine, Thanks

Positively STUNNING!!!
Great job!!
TFS

OMG thia ia juat beautiful I can't wait to use it I cut it as a silouette on Paper it cut wonderfully. I would like to be able to do this I have been working on a abrrel racer 7" tall by 6" wide for a piece of glass that has broken in my cupboard but can't seem to get it. I think it could go on a quilt with team roper , goat tyer, calf roper, bull rider etc. etc. omg I wish i could figure out inkscape.


anyhow

TFS

Just wishful venting hehehe

bumping up for Sarah