Craft Edge

Hi Everyone,

I am new to the forum and Dawn suggested that I reach out to the people here.

I make vinal masks for airrbrushing model aircarft. I have a stencil set that has very fine detai and cannot idnetify the vinyl type, It seems a lot thinner than my normal produck which is oramask 810 and has a grey matt finish. It is low tack.

this distace between the inner cut line and outer cut line is .5 (half) a mm. Oramask 810 is 80microns. Thinness is imprtant becuase when using the masl one prasys the outer color first and them the inner color. This produce a thin border. That is the application.

I would appreciate any help or suggestions

Thanks
Sean

I have now had the vinyl measured without the backing sheet and it is an incredible 10 microns. Does anybody have any idea where I can purchase a something like this or similiar?