Page 1 of 1
Can not activate scal3
Posted: Wed Nov 18, 2015 1:06 pm
by Snijderke
Hi, I tried to install my scal3 (bought on a physical cd).
After installing the software, I have to activate. Since there is no internet connection on my laptop, I always get error-messages.
I filled in the Name and the serial numbers from the cd-case.
I tried manytime, but without any succes.
Please help me!!!
Note : laptop with windows-XP
Re: Can not activate scal3
Posted: Wed Nov 18, 2015 3:22 pm
by papasue
This is a question for CraftEdge guru's. (they do no drop in here very often). There is a form on craftedge.com for direct support. Good luck.
Re: Can not activate scal3
Posted: Thu Nov 19, 2015 9:47 am
by talanhart
Where did you buy your CD? There a lot of Pirated Versions on E-bay.
Re: Can not activate scal3
Posted: Thu Nov 19, 2015 10:34 am
by Snijderke
Hi Todd, my software was included with a GCC-iCraft cutter; she was completely legal!!!
She was installed on my desktop-pc (with an internet-connection). But since I use my laptop, to give demonstrations, I want scal to install on my laptop. The only problem is: I have no internet-connection on the laptop to get an activation-code.
Thanks for watching my post.
Greetings from Belgium.
Re: Can not activate scal3
Posted: Mon Dec 28, 2015 9:51 pm
by ScrappyDew
You will have to go through the process of activating it manually. You may get an error when you do it manually as you can only register it on two computers. If you do get an error doing it the manual way make sure you click the link on the website saying deactivate a copy. This will allow you to register and activate it.