Page 1 of 1
Cutting thru design
Posted: Sat Oct 31, 2015 4:20 am
by wynnepam
I have a cricut expression and for some reason, it is wanting to cut lines thru my design. I have had this problem before and cant remember how it was fixed. Sometimes it will cut letters in to. Any suggestions.
Re: Cutting thru design
Posted: Sat Oct 31, 2015 6:35 am
by ScrappyDew
Is your program in trial mode? Does this happen when you use a cartridge (could be blade drag)?
Re: Cutting thru design
Posted: Sat Oct 31, 2015 12:38 pm
by wynnepam
Its not in trial mode. I use the same cartridge all the time.
Re: Cutting thru design
Posted: Sat Oct 31, 2015 12:59 pm
by ScrappyDew
When asking about the cartridge. If you are getting stray cut lines when cutting from your machine itself using cartridge ONLY then we can rule out it being a SCAL program rather a machine problem.
Re: Cutting thru design
Posted: Mon Nov 02, 2015 7:11 am
by wynnepam
I am only using the cartridge because I have to with the machine. I am cutting my own designs. I ususally have to cut it 2-3 times to get a good one I can use.