Is this normal?
Posted: Sun Dec 01, 2013 4:10 pm
Hi,
When I was cutting out a sheet full of raindrops on my Gazelle (using SCAL 3) I noticed that the lights on my gazelle where flashing- the speed lights and the force lights. They would l light up in different patterns, it freaked me out (I've only been using this machine for a week now) so I turned it off, then resent the file for it to cut and it did it again. It does not seem to actually change the speed or the force of the cuts.
I'm starting to thing something is wrong- this is the third issue I've had with no explanation. The other is that randomly the cutter will stop cutting the a shape and take off cutting across the paper in a straight line.
Thanks for your help,
Nancy
When I was cutting out a sheet full of raindrops on my Gazelle (using SCAL 3) I noticed that the lights on my gazelle where flashing- the speed lights and the force lights. They would l light up in different patterns, it freaked me out (I've only been using this machine for a week now) so I turned it off, then resent the file for it to cut and it did it again. It does not seem to actually change the speed or the force of the cuts.
I'm starting to thing something is wrong- this is the third issue I've had with no explanation. The other is that randomly the cutter will stop cutting the a shape and take off cutting across the paper in a straight line.
Thanks for your help,
Nancy