Page 1 of 1
3-D cone
Posted: Tue Apr 23, 2013 5:47 am
by juliegodinez
Hello,
I am looking for instructions for making a 3-D cone shape that can be cut, assembled and filled. I need to make it approx. 5-6" tall.
Thank you so much!
Julie
Re: 3-D cone
Posted: Tue Apr 23, 2013 4:43 pm
by BobSa
I made it to fit on a 8 1/2 X 11 sheet.
It has a 1/4 inch glue tab.
4 5/8 diameter -- 5 3/4 tall.
You will need to position it within a 1/4 (.250) of the top of the sheet, It is 6 3/16 wide so the sideway position is not critical.
.
Enjoy
- cone.svg
- (1005 Bytes) Downloaded 286 times
Re: 3-D cone
Posted: Wed Apr 24, 2013 12:10 pm
by mitsim
Here are a couple of freebies you can take a look at. One is a party hat, which could be inverted. Anyway, can't hurt to take a peek, since they are both freebies.
http://svgcuts.com/blog/2012/10/20/chri ... -svg-free/
http://svgcuts.com/blog/2011/02/15/free ... party-hat/
Good luck!