Craft Edge

I have two PCut machines. Up until a few weeks ago, they both worked with scal3 like champs.

Now when I go to "cutter" and then "cut with uscutter" - it goes through the motion except cutting and I get the pop-up
"cutting data was sent to cutting machine" but no action.

Anyone else having an issue like this??

make sure you did not change the setting on your machine by mistake.

also make sure windows (or your OS) has not changed/lost your USB ports
if the OS says the cutters are on port 3 and scal thinks they are on port 2 they won't "see" each other.

Gaz

Fixed YAY!!!

Thanks, support team!