Craft Edge

Help!

Hey everyone! I have a problem and I hope you can help! I just got a new computer and installed my old version of SCAL but I've lost the ability to place a picture into the file. What happened? I believe my old version was 2.043 and now this version is 2.030. What can I do? Help! Oh and? I have a cricut so I'm afraid to update.

Thanks!

you might need to contact craftedge as I'm not sure that 2.30 is compatible with the cricut.
they should also be able to help with the non place image - I have never used scal lower then 3 so not sure what else to suggest.

Gaz

Thanks for the message--just contacted them! fingers crossed...

SCAL2 should be updated to version 2.044, which is the last version made prior to the PC lawsuit. So, it will probably do what you need it to if you update to that version (which is free, of course).

Thanks mitsim! And that's what Craft Edge did for me!