Page 1 of 1
Scal3 and Ecal
Posted: Tue Aug 28, 2012 2:02 pm
by Tam
Friends can someone tell me if Scal 3 and Ecal are the same except for the drivers or the Eclips. I have both softwares installed and not sure I need them both. I know I have to have my Ecal because of cutting with my Sizzix. Just wondering.
Thanks
Tam
Re: Scal3 and Ecal
Posted: Tue Aug 28, 2012 4:06 pm
by gj1
Not sure there is a reason to have scal3 if you use ecal...they are the same, I believe. HOWEVER, I am not an authority on this, as I don't have ecal. You might want to wait for someone else's response, too. BTT for answer, please.
Re: Scal3 and Ecal
Posted: Thu Aug 30, 2012 11:46 am
by Tam
U know I can find nothing different in the two programs other than my eCal has the drivers to cut to my Eclips. O and you can only cut to the Eclips with eCal and wit Scal3 you can cut to your other cutters, like my Cameo. So I guess it is good to have both if needed.
Re: Scal3 and Ecal
Posted: Fri Aug 31, 2012 5:20 pm
by Aimitup2
You are correct Tam - Ecal and SCAL 3 are similar - Ecal only works with the Sizzix Eclips. You'll need the SCAL 3 to use with other cutters.
Re: Scal3 and Ecal
Posted: Sat Sep 01, 2012 2:50 pm
by gj1
Thank you, Amy, for jumping in and responding...I was not certain. By the way...omg, I love all your creations using svgcuts, on your blog!!! AWESOME!!!
Re: Scal3 and Ecal
Posted: Sat Sep 01, 2012 7:06 pm
by Tam
TY Amy I was almost sure that was the reason...But glad u chimmed in to let us know for sure..
Thanks