Craft Edge

Would really appreciate any advice or comparisons between these two machines.

Am very keen to get a new cutter soon and have narrowed it down to one of these.

many thanks,
S

viewforum.php?f=85

You could start with our cutter review section.

Hi,

Thanks for replying.

I have done alot of research but cannot find any really good articles/videos etc comparing these two machines specifically.

I was hoping for for someone who has both could maybe give me a low down of pros/cons etc.

If you do a search for their forums, you might get better info there on these particular machines.

The Zing does not work with scal so you would have to use MTC The gazelle can use both programs and also is shipped with funtime software the zing is up to 13 " wide cutting the gazelle is 12" the new gazelles are able to do pnc also price is about equal and but depending on your preferences and what you wish to do is the deciding factor.

The KNK Zing can cut up to 14" wide, not 13".