Craft Edge

Hello, I use the Cricut expression with Scal 2. I started to cut a design out, but the blade/andHousing will not move from the right side of the mat, it just cuts there even tho I have the design on the left margin. Can someone please tell me what I need to do to correct this problem? There are no instructions from ProvoCraft ( as usual) to help with this problem. thanks so much, I need to cut, lol!!!

Did you try to cut using just a cartridge (no SCAL) and are you getting the same results?

Go to this link and here are some trouble shooting tips from CE.

http://www.craftedge.com/support/cricut ... reset.html