Page 1 of 1
TROUBLE NEED HELP PLEASE !!!!
Posted: Sun Jul 10, 2011 9:47 am
by ssuzanlyn
When I try to cut with scal I am getting a erro stating your cricuit needs to have firmware v1.5.1-V1.54 what in the heack is this and what do I need to do ???
Re: TROUBLE NEED HELP PLEASE !!!!
Posted: Sun Jul 10, 2011 9:52 am
by sstehman
SCAL 3 does not cut with the Cricut.
Re: TROUBLE NEED HELP PLEASE !!!!
Posted: Sun Jul 10, 2011 9:54 am
by ssuzanlyn
I dont have 3 it is 2.043
Re: TROUBLE NEED HELP PLEASE !!!!
Posted: Sun Jul 10, 2011 10:43 am
by gj1
You will have to contact the manufacturer of the cutter and get the directions for updating your firmware, I think...or someone else may have ideas, or use the search at the top right...this question has been asked before. I forget how to do it.
Re: TROUBLE NEED HELP PLEASE !!!!
Posted: Sun Jul 10, 2011 11:38 am
by sstehman
Will send you a pm on how to update firmware.