Craft Edge

Here is a design to share. Probably will use it to make a card for my mother.

Very very nice Sandy. .Great job.. I hadn't even realized it was MOthers Day this weekend until hubby informed me..LOL

Well....I just learned something so I am reposting the SVG. I was watching Carolyn's video on a completely different subject, but while watching it, I learned that if I want both sides of my lines to cut, I need to choose Path -- stroke to path. Now I'm sure I've read that somewhere, but didn't get it until I used it. So I went back and looked at this posting and realized it would not cut the way I wanted.

The other thing I stumbled on by mistake is that when I go to Display mode - outline, I can see that both lines are now there for the line I want to cut ---- but...it doesn't end there. Apparently there were some odd shapes I was probably playing around with hiding there also and I needed to delete them.

So, thank you Aussie Carolyn as I'm much happier now that it is cleaned up and hope I didn't inconvenience anyone trying to cut the original messy design.

I like all the swirls :P