Craft Edge

Hi,
I have been trying to cut 3D roses, but when they are cutting it scores right across therefore I cannot role them into shape, can anyone tell me what I am doing wrong, I have cut these in the past and they were okay.
Thanks in advance,

Make sure that the file is not touching the cutting boundary. Your file probably has an open Path, and SCAL2 will connect the end-points if it is touching the cutting boundary. I usually use the alignment tools, then give it a nudge away from the edge. Preview will also show if SCAL will add the closing line. I have a thread on this in the bugs section. http://forums.surecutsalot.com/viewtopi ... =7&t=17956