Craft Edge

I am trying to make a charger plate and the text at the bottom is upside down. I spent most of the evening looking at tutorials since I am a newbie. After posting a question on one of the forums I find I have to go outside SCAL2 to do it

Please this would be so helpful!

No, you don't need to go outside of SCAL to do this. Select the circle, then use Path/Reverse path. You will need two circles if you want the text at the top to go in the opposite direction.

I've got a video on this. The bottom text right side up is at the end of the video.
http://cleversomeday.wordpress.com/2010 ... t-on-path/