Rulers
Posted: Mon Nov 08, 2010 11:26 am
I'd like to see the page rulers set to at least 1/16 of an inch increments.
Also, rulers "0" (zero) mark would be better displayed starting at the actual cutting line (dotted line), rather than a 1/4" outside of the usable surface.
I do a lot of work that requires precise alignment and these improvements would make SCAL so much nicer to use.
Will
Also, rulers "0" (zero) mark would be better displayed starting at the actual cutting line (dotted line), rather than a 1/4" outside of the usable surface.
I do a lot of work that requires precise alignment and these improvements would make SCAL so much nicer to use.
Will