Craft Edge

I am trying to create a computer mouse which I can cut REALLY big in vinyl. It will be used on the walls of the local middle school's computer lab walls. I've got the insides of the mouse but I need an outline or base cut. The sections of the mouse will be gray, the track ball will be dark gray and the base will be black. I can't figure out how to create the base.

Any help would be appreciated.

I've never posted before (always just been a lurker) so I'm not certain this is working. Thanks in advance.



KSDerby

Is this what you are needing???

here is one i did not sure if it is what you are looking for

Almost, it shouldn't have the middle indentation. Ideally it would be rounded at the top.

Can you tell me how you did that?

this is perfect. Thank you rachell.

you could just delete the node off the middle curves and it will round out.. click on the nodes in scal and then use the backspace button..

Thank you to everyone for your help. I now have various sized computer mice all over my craft room (and one very cute animal mouse). I'll post pictures when I have them up on the wall.

I think I'm going to be looking for a little more help soon. I've made a graphing calculator (although I still need to figure out how I'm going to make the arrow on the graph). I need to make an abacus, compass (the type used in geometry classes) and protractor. Right now the abacus is giving me fits. If anyone knows of a site with math "stuff" that is already set-up for SCUT or SVG's that have been divided, I'd love to know about it.

Again, thank you everyone. I appreciate the support and help.

ok tried to add the file it says too big if you would like the file for the image let me know and i can email it to you

this is the abacus counter in old syle

Try this site. They have a lot of public domain vectorized images. There are some that aren't cutter-friendly, but you might find some that you can use.

http://www.clker.com/