Craft Edge

I was using CDS for the first time in awhile this morning and it says I need to do a firmware update. I'm leery of this, given that I don't want to mess up my SCAL. Does anybody know if there's a way to bypass or override the software when it says you have to do a firmware update? As of now, my CDS is useless unless I do the update.

I was leery too. Don't worry. It won't mess up SCAL.

SO the answer is to go ahead an update?

Correct! I have the latest and greatest firmware and SCAL works perfectly fine for me.

Thanks. I will give it a try then!