Craft Edge

Craftedge emailed me and they repaired the latest update.. I took a chance and reinstalled only I did save the earlier version this time..LOL .. I am now cutting with the newest update and IT WORK!!!! Great job Todd!!!

Good news. Did you try all the new additions?

Not yet.. I'm mucking with them now.. LOL

I am off to download now! I will try to work with mine today. I hope it will be better than yesterday!

That update fixed the problem with gradient fills too.

So far so good! I am hoping I can update finally!

Read your comments and decided to give the new .011b update a whirl. Yay!!......we seem to be back in business again! Now need to go find out what is new. Thank you Jo-anne for being brave enough to be the first to try this! LOL

Barbara

What sorta problems were there that we may have noticed, so we can tell if we had them and didn't recognize them (or did see a problem) and tell if the rest of us should upgrade--thnx

Good to know, I was holding out for a bit to see what was happening with it.
Yippie, I will update to the "b" version now

You are so welcome..

The problem was that SCAL2 was saying cutting was complete when I didn't even start.. But now they fixed it.. YAYYYY.. I'm a happy camper can ya tell??LOL... Oh and the fact that the sun is shining and it's in the high 50's.. Snow is almost gone helps as well.. Very unusual for our neck of the woods at this time of year ..