Craft Edge

Posted: **Tue Dec 08, 2009 12:16 pm**

Love it! I can't wait to see the interpretation from others too!!
Robin

Posted: **Tue Dec 08, 2009 12:42 pm**

I have a font called otannenbaum that has a lot of different christmas trees and could be used to make this mesh. However, my computer is down, try scrapnfonts, I think I got it there.

Posted: **Tue Dec 08, 2009 1:34 pm**

DogCarbon....

Ah, and AWE and then some. I cut IT! Mac/SCAL2 and it is gorgeous!! and then some. Cut just perfectly at 9x9. I'd be most happy to post a picture of the cut file if you don't have one.

THANKS

Now I better go cut Todd's file!

Posted: **Tue Dec 08, 2009 1:38 pm**

Nope, I don't have a picture of the cut file, since I just created it

Please post one!

I would LOVE to see it

Posted: **Tue Dec 08, 2009 2:08 pm**

I didn't quite get all the little pieces out, but that's my fault as they did cut I just didn't poke all of them.

It is wonderful, sorry if the picture doesn't show it off at its best.

: DogCarbonMess.jpg (141.04 KiB) Viewed 5839 times

Posted: **Tue Dec 08, 2009 2:25 pm**

i LOVE it!

Posted: **Tue Dec 08, 2009 2:45 pm**

Absolutely beautiful! Thanks for all of your hard work!!
Ronin

Posted: **Wed Dec 09, 2009 4:12 am**

PERFECT!!!!

Just what I was looking for! You guys are the best! I just love all the talent on this board!

Merry Christmas,
~Teri~

Posted: **Tue Feb 16, 2010 9:08 am**

Absolutely awesome, thank you so much!

Craft Edge

ISO: Christmas Tree Mesh

Re: ISO: Christmas Tree Mesh

Re: ISO: Christmas Tree Mesh

Re: ISO: Christmas Tree Mesh

Re: ISO: Christmas Tree Mesh

Re: ISO: Christmas Tree Mesh

Re: ISO: Christmas Tree Mesh

Re: ISO: Christmas Tree Mesh

Re: ISO: Christmas Tree Mesh

Re: ISO: Christmas Tree Mesh